作业帮求高手翻译模具英语,急,急,急. the cavity and or core block can be removed from the parting line 接着上面的,一次输不完the cavity and or core block can be removed from the parting line of the tool without removing the mold from the
来源：学生作业帮助网 编辑：作业帮 时间：2024/04/28 05:14:46
求高手翻译模具英语,急,急,急. the cavity and or core block can be removed from the parting line 接着上面的,一次输不完the cavity and or core block can be removed from the parting line of the tool without removing the mold from the
求高手翻译模具英语,急,急,急. the cavity and or core block can be removed from the parting line
接着上面的,一次输不完the cavity and or core block can be removed from the parting line of the tool without removing the mold from the press. To accomplish this it requires less clearance in the support plate so that the ejector pins retain alignment once the cavity block is removed. The ejector pin holes will require a gradual transition from a clearance diameter in the rear of the block to a tight fit at the front of the block. This is most often accomplished with a double pass wire edm process, one pass cuts the taper for clearance and the second cut finishes the fit diameter for a length of 2-3 times the ejector pin diameter. The cavity and core blocks also require bolts that are accessible from the parting line and usually also have a jack screw thread machined into the bolt clearance diameter so that smaller bolts can be used to jack the cavity block out of a pocket.
求高手翻译模具英语,急,急,急. the cavity and or core block can be removed from the parting line 接着上面的,一次输不完the cavity and or core block can be removed from the parting line of the tool without removing the mold from the
对模具我了解有限,我着翻译一上,难点在于一些名词在模具中不知叫什么,你已猜一下吧：
在模具没从冲床移出时,凹位和下模镶件可能会从工具的分模线的地方掉出来,在支撑块需要更小的间隙,以便确保被移动时顶针定位,要求顶针孔慢慢从这个块后边的间隙转到这个块的前边,这常用双程丝电火花放电加工,一个为间隙加工锥形,另一个加工2-3倍于顶针直径的长度,凹位和下模镶件需要可以从模缝线进去的螺丝,也常用一个加工了牙的螺丝进入间隙,以便更小的螺丝能顶起阴模